ANDREWS Conversion Chain Driven Cam — N Series, Chain conversion – 99-06 Touring, 00-06 CVO, 00-06 Softail, 99-05 Dyna

Upgrade '99–'06 Twin Cam motors (except '06 Dyna Glide) to roller-style cam chains and replace spring-tension chain adjusters with later-style hydraulic adjusters for longer life. ⚙️

• Allows the upgrade to newer roller-style cam chains and replaces the spring-tension adjusters with hydraulic adjusters for improved durability and reduced maintenance.
• Cam grinds listed are designed for use with stock lifters; installation requires a '07–'17 cam plate, oil pump, cam sprockets and chains, and both hydraulic chain adjusters (these parts are not included and must be purchased separately).
• A list of required components is supplied with each set of cams to simplify parts selection.
• Performance should be similar to earlier bikes with the same cam grinds when installed properly.
• Made in the USA. 🇺🇸
• Technical note: earlier motors cannot accept the later cam designs due to a different bearing journal diameter; earlier motors use a .875" bearing journal while later-design cams are 1.000" in diameter. Some cams feature the .875" journal yet still accept the newer cam support plate.
• '99–'01 model motors require a specific rear cam sprocket; '02–'06 models must use the stock rear cam sprocket, OEM #25728-06.
• Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance before first run.